Pin-up Girls - Amethyst Lace Bra Pattern
Regular price $20.00
Shipping calculated at checkout.
The Amethyst Lace Bra Pattern has an offset vertically seamed cup and can be made with or without foam lining. Over 100 sizes from BCD 3.0 to BCD 6.0 The Amethyst is a full band bra, so it can be worn with or without wires. It features an off-set vertical seamed cup for the roundest styling, and a shortened upper cup for maximum lift. It has been specially designed to use with foam lining, therefore enabling you to use virtually any stretch fabric over it as a cup cover. But it can even be made without foam, using low-stretch fabrics or fabrics lined with Sheer Cup Lining. The Amethyst has a band made from lace edging, so the scallops of the lace actually follow the contour of the bottom edge. The centre front seam will allow you to mirror the lace perfectly on both sides of the frame. The lace edging is also used along the neckline of the upper cup where the scallops peek out over the foam lining. What’s more, the strap extension also sports lace edging! The sizing for the Amethyst is a bit different from other bra patterns, in that we use the Bottom Cup Depth (BCD) to determine the size of the cup. This is the measurement from the wire line at the base of the cup up to the location of the apex. It is much more accurate than relying on Ready-to-wear bra sizing, which can differ from company to company. Determine your BCD by measuring your best fitting bra between these two points. All cup sizes from 3.0 to 6.0 are included in the pattern. Combine these 13 cup depths with 1 of 8 band sizes from 26″ (65 cm) through 40″ (100 cm) to make the Amethyst Lace Bra Pattern size range equivalent to over 100 unique bra sizes. Required Materials for Amethyst: 0.3 m ofCut & Sew Foam Lining(only if using foam lining) 2 m Stretch Lace Edging to cover cups and frame (For View A) or 1.5 m Stretch Lace Edging for upper cups and frame (For view B) 0.5 m of stretchy fabric to cover the cups (if using foam lining) 0.5 m of stable fabric such as Duoplex orSheer Cup Liningfor the cups (if not using foam lining) and for the frame 0.3 metres ofPower Netfor the back band 0.7 m or less of 3/8″ finished widthFold-over Binding 1.1 m or less of ½” Plush-Back/Band Elastic for bottom band 1.2 metres of ⅜” Plush Back/Band Elastic for top band 0.5 metres of 3/8″ wide strip of stabilizer for the neckline 1.0 – 1.2 m of of Strap Elastic 5/8″ wide for BCD sizes 3.0-4.5 and 3/4″ wide for sizes 4.75 to 6.0 1.0-1.2 m of double face satin ribbon, 1/2″ or 5/8″ to use as a stabilizer under the front part of the strap elastic 2 sliders and 4 rings width to match the strap elastic, either 5/8″ or 3/4″ wide 1 metre ofUnderwire Casing 1 Hook & Eye Set for the back (2 hooks high for sizes 3.0-4.5 and 3 hooks high for sizes 4.5-6.0) 1 Bow Embellishment for the front (optional) 1 set of Underwires